|
[Sponsors] |
how to create a logarithmic boundary layer input? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 30, 2013, 12:40 |
how to create a logarithmic boundary layer input?
|
#1 |
New Member
Gustavo Garcia
Join Date: Aug 2013
Posts: 1
Rep Power: 0 |
Hello,
We are trying to create a logarithmic boundary layer velocity profile for eg simulation of buildings. somebody has used this type of entries in OpenFOAM? thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blasius boundary layer coupled with thermal boundary layer | primary.destination | Main CFD Forum | 0 | May 7, 2012 03:55 |
Boundary Layer roughness/ low reynolds wall treatment | Luigi_ | STAR-CCM+ | 1 | March 14, 2012 09:40 |
[snappyHexMesh] snappyHexMesh: create boundary layer in a bent tube | brahim | OpenFOAM Meshing & Mesh Conversion | 10 | September 5, 2011 10:43 |
[blockMesh] Include list of points | Hikachu | OpenFOAM Meshing & Mesh Conversion | 0 | June 20, 2011 10:03 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |