Simulation of atmospheric boundary layer

Bazinga · February 18, 2014, 05:00

Dear all,

I am trying to have a simulation with an atmospheric boundary layer at the inlet. I was using the inlet conditions of the turbinesiting tutorial but I realized that the function atmBoundaryLayerInletVelocity sets Umax = Umax which is not what I want. I tried to delete the code which sets the velocity above Href to Uref but it didnt work for me.

Any ideas on how to create a ABL with the logarithmic velocity profile.

Thanks in advance

gonpe · February 19, 2014, 13:15

Have you looked at the swak4Foam libraries? They are handy for this sort of thing.

February 18, 2014, 05:00	Simulation of atmospheric boundary layer	#1
Bazinga Senior Member Join Date: Jun 2012 Location: Germany, Bochum Posts: 230 Rep Power: 17	Dear all, I am trying to have a simulation with an atmospheric boundary layer at the inlet. I was using the inlet conditions of the turbinesiting tutorial but I realized that the function atmBoundaryLayerInletVelocity sets Umax = Umax which is not what I want. I tried to delete the code which sets the velocity above Href to Uref but it didnt work for me. Any ideas on how to create a ABL with the logarithmic velocity profile. Thanks in advance

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 05:45
[snappyHexMesh] Boundary layer generation problems	ivan_cozza	OpenFOAM Meshing & Mesh Conversion	0	October 6, 2010 13:47
car simulation - boundary layer street	sanchezz	CFX	8	January 13, 2010 18:05
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
urgent: 2d laminar boundary layer simulation	Abhishek	Main CFD Forum	2	August 1, 2006 19:17

February 19, 2014, 13:15		#2
gonpe Member Goncalo Pedro Join Date: Nov 2009 Location: Victoria, British Columbia Posts: 30 Rep Power: 17	Have you looked at the swak4Foam libraries? They are handy for this sort of thing.