|June 10, 2014, 14:08||
parabolic velocity: simple way to implement this bondary condition?
Join Date: Jan 2014
Posts: 51Rep Power: 5
I am newbie in openfoam I saw some posts on the subject, at first I was scared. Could someone show me how to implement the parabolic velocity profile to the input of my tube (2D)? What do I do? Thanks for attention and sorry for posting this topic again. If I can implement, I will make a pdf manual for beginners to share here.
Thank you for your attention.
I use OpenFOAM 2.3.0
|June 11, 2014, 04:55||
Join Date: Jul 2009
Blog Entries: 1Rep Power: 10
Using groovyBC you can do that, check out the example on "pulsedPitzDaily".
Also, you can refer to the chalmer's document. By following the instruction in the document you can use the patch "parabolicVelocity". I don't know much about OF 2.3.0 version, whether this BC is available in the same. If not you can install the BC using the instructions mentioned in the document.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem with assigned inlet velocity profile as a boundary condition||Ozgur_||FLUENT||5||August 25, 2015 04:58|
|Condition of Air velocity in Open Channel simulation||wes1204||OpenFOAM Running, Solving & CFD||0||May 9, 2014 05:08|
|How do I prescribe Average Velocity /Total Inlet Flow for a simple channel problem?||skuznet||OpenFOAM Pre-Processing||3||December 1, 2013 23:54|
|implement tangential boundary condition in simple||jhuang||Main CFD Forum||4||July 10, 2006 04:01|
|what the result is negatif pressure at inlet||chong chee nan||FLUENT||0||December 29, 2001 06:13|