 |
 |
 |
|
|
|
[Sponsors] | ||||
CHT with non-conformal meshing using partialggi |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 15, 2015, 09:44
|
CHT with non-conformal meshing using partialggi
|
#1 |
|
Member
AJ
Join Date: Sep 2013
Posts: 30
Rep Power: 14  |
Hello Fomers,
I was trying to simulate CHT with a hex fluid with tet solid, a sample case with partialggi using chtMultiRegionFoam, openfoam-3.0-ext . I was confused with the selection of boundary type for interface. Normally with a mapped wall or directly mapped wall, we have soildwallmixedtemperaturecoupled or compressile::* . Is there a specific boundary type to assign the interface while using partialggi |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Conformal meshing with trimmer meshing model | crevoise | STAR-CCM+ | 2 | July 25, 2013 18:30 |
| Meshing in CHT Problem | Markat | FLUENT | 9 | January 13, 2013 16:45 |
| [ANSYS Meshing] ANSYS meshing for CHT problem | sandy_1982 | ANSYS Meshing & Geometry | 0 | November 23, 2012 14:00 |
| [Commercial meshers] non conformal interface, meshing, inverted volume | araghunath | OpenFOAM Meshing & Mesh Conversion | 1 | April 7, 2011 05:27 |
| Is conformal meshing really an advantage? | Alvin Szeto | Main CFD Forum | 19 | June 27, 2003 08:23 |
Linear Mode
