Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

Where does the mirrorMesh command store the new file?

Mark Forums Read

Reply

Search this Thread

June 11, 2015, 16:30	Where does the mirrorMesh command store the new file?	#1
arb93 New Member Alex Benjamin Join Date: Jun 2015 Posts: 6 Rep Power: 12	Hey! I am new to OpenFoam! Just curious as to where mirrorMesh writes the new file to? Thanks!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
centOS 5.6 : paraFoam not working	yossi	OpenFOAM Installation	2	October 9, 2013 02:41
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12	keepfit	ParaView	60	September 18, 2013 04:23
[swak4Foam] swak4Foam-groovyBC build problem	zxj160	OpenFOAM Community Contributions	18	July 30, 2013 14:14
"parabolicVelocity" in OpenFoam 2.1.0 ?	sawyer86	OpenFOAM Running, Solving & CFD	21	February 7, 2012 12:44
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 12:46

All times are GMT -4. The time now is 03:16.