Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

Skewness number

Mark Forums Read

Reply

Search this Thread

November 9, 2015, 20:36	Skewness number	#1
JulytoNovember Member Jason Eason Join Date: Jan 2010 Location: Portage, Michigan Posts: 45 Rep Power: 17	Could someone tell me how skewness is calculated via OpenFOAM's checkMesh? 1. Is the skewness number base on volume or angle. 2. Is the skewness number base on the highest skewed cell? Or an average of the summation of all cells?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
foam-extend_3.1 decompose and pyfoam warning	shipman	OpenFOAM	3	July 24, 2014 08:14
Cluster ID's not contiguous in compute-nodes domain. ???	Shogan	FLUENT	1	May 28, 2014 15:03
decomposePar pointfield	flying	OpenFOAM Running, Solving & CFD	28	December 30, 2013 15:05
Severe nonorthogonality and severe skewness problem	qtian	OpenFOAM Running, Solving & CFD	2	January 22, 2008 18:47
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 21:37.