 |
 |
 |
|
|
|
[Sponsors] | ||||
December 9, 2015, 05:47
|
ultimate analysis in OpenFOAM
|
#1 |
|
Senior Member
Przemek
Join Date: Jun 2011
Posts: 249
Rep Power: 16  |
Hi Foamers,
I am trying to do some chemical-combustion simulations in OpenFOAM. I did it previously in fluent and there one has to provide data from ultimate analysis (i.e. % of mass of C, O, H, etc.). However in the OpenFOAM I do not see in the available solvers, for instance in fireFoam, where I can set it up. Is it unnecessary or I missed something?
__________________
best regards pblasiak |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OpenFOAM stress analysis results are showing 8-10% error with analytical solution. | Sargam05 | OpenFOAM | 3 | May 5, 2017 11:39 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
| use of openfoam in attic analysis | kirankarki | OpenFOAM | 1 | September 12, 2010 21:02 |
| Cross-compiling OpenFOAM 1.7.0 on Linux for Windows 32 and 64bits with Mingw-w64 | wyldckat | OpenFOAM Announcements from Other Sources | 3 | September 8, 2010 06:25 |
| OpenFoam for mold flow analysis | KyleL | OpenFOAM Pre-Processing | 1 | March 2, 2010 06:55 |
Linear Mode
