noSlip or fixedValue

FlyBob91 · October 24, 2016, 09:58

Hello to all,
just a simple (and maybe stupid) question.
Is there any differences between the noSlip boundary condition and the following one?

Code:

        type            fixedValue;
        value           uniform (0 0 0);

Thanks for help

Antimony · October 25, 2016, 01:16

Hi,

I could be mistaken, but if I remember correct, noSlip is a recent introduction (seems to be from OF 4) that is supposed to do the same thing as fixedValue (0 0 0)...

Link: https://github.com/OpenFOAM/OpenFOAM...98d0b13f22b515

Cheers,
Antimony

October 24, 2016, 09:58	noSlip or fixedValue	#1
FlyBob91 Senior Member Join Date: Mar 2016 Location: Bergamo Posts: 157 Rep Power: 10	Hello to all, just a simple (and maybe stupid) question. Is there any differences between the noSlip boundary condition and the following one? Code: type fixedValue; value uniform (0 0 0); Thanks for help

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Issue symmetryPlane 2.5d extruded airfoil simulation	281419	OpenFOAM Running, Solving & CFD	5	November 28, 2015 13:09
my first Natural Ventilation case with OpenFOAM	alessandro.zomparelli	OpenFOAM Running, Solving & CFD	3	April 1, 2015 10:16
Problem where FixedValue Inlet meets noSlip Wall	VSass	OpenFOAM Pre-Processing	0	May 31, 2013 05:13
[swak4Foam] Air Conditioned room groovyBC	Sebaj	OpenFOAM Community Contributions	7	October 31, 2012 14:16
FOAM FATAL IO ERRORsimpleFoam	hariya03	OpenFOAM Running, Solving & CFD	6	July 16, 2008 08:03

October 25, 2016, 01:16		#2
Antimony Senior Member Join Date: Aug 2013 Posts: 407 Rep Power: 15	Hi, I could be mistaken, but if I remember correct, noSlip is a recent introduction (seems to be from OF 4) that is supposed to do the same thing as fixedValue (0 0 0)... Link: https://github.com/OpenFOAM/OpenFOAM...98d0b13f22b515 Cheers, Antimony