 |
 |
 |
|
|
|
[Sponsors] | ||||
June 22, 2016, 05:23
|
Swirl flow rate inlet velocity in a wedge
|
#1 |
|
New Member
Aldo Sestito
Join Date: Jun 2016
Posts: 3
Rep Power: 9  |
Hello there,
I am trying to set up a swirling boundary condition for a gas for the inlet patch of a cylinder, considering only a section of it (wedge). By using the swirlFlowRateInletVelocity, I don't obtain a rotation around the cylinder axis., but around an internal point of the wedge. Here I attach a picture of what happens. Does anybody know how to manage it? Best regards |
|
|
|
|
|
December 5, 2016, 05:42
|
|
#2 |
|
New Member
Padhmini Priyadharshini Shivaraj
Join Date: Jul 2016
Posts: 3
Rep Power: 9 |
I am facing the same problem. Did you figure out the reason?
|
|
|
|
|
|
 |
| Tags |
| swirl, wedge |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Velocity Profile at inlet if Mass flow rate BC is given | Struggle_Achieve | OpenFOAM Running, Solving & CFD | 3 | April 14, 2019 21:03 |
| Incompressible flow velocity: outlet faster than inlet | Xuekun | Main CFD Forum | 13 | October 30, 2015 14:52 |
| DPM total mass flow rate | yow | FLUENT | 0 | July 17, 2015 12:01 |
| Problem with time average tangential velocity in swirl flow. | lakhi | FLUENT | 5 | July 18, 2012 16:28 |
| mass flow inlet | Denis Tschumperle | FLUENT | 7 | August 9, 2000 02:19 |
Linear Mode
