Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

converting FluentmeshtoFoam

Mark Forums Read

Reply

Search this Thread

March 12, 2017, 05:55	converting FluentmeshtoFoam	#1
manuc Senior Member Manu Chakkingal Join Date: Feb 2016 Location: Delft, Netherlands Posts: 129 Rep Power: 10	Hello all Is it possible to run fluentmeshtofoam in parallel. Since the number of grid points are really high , its taking long time do the conversion. Is there any work around to make it fast __________________ Regards Manu

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Converting an abaqus mesh using matlab scripts and fluentMeshToFoam	MichaelD	OpenFOAM Meshing & Mesh Conversion	1	July 2, 2014 06:34
[Commercial meshers] fluentMeshToFoam instead of fluent3DMeshToFoam	sasanghomi	OpenFOAM Meshing & Mesh Conversion	2	March 29, 2013 07:58
[Commercial meshers] Converting a mesh with splitted cells using fluentMeshToFoam	jlpelerin	OpenFOAM Meshing & Mesh Conversion	4	April 25, 2011 16:56
problem when converting mesh (made by ICEM) using fluentMeshToFoam	Forrest_Lei	OpenFOAM	11	October 16, 2009 06:28
[Commercial meshers] Problem with fluentMeshToFoam	whitecat	OpenFOAM Meshing & Mesh Conversion	4	September 1, 2008 05:31

All times are GMT -4. The time now is 09:35.