|
[Sponsors] |
April 28, 2017, 11:37 |
mappedPatch
|
#1 |
Member
Arnout
Join Date: Nov 2010
Posts: 46
Rep Power: 15 |
Hi,
I try to use a a cut through my domain as inlet condition. I'm using a mappedPatch type of inlet. My geometry is a simpel pipe with a 90o bend. I would like to map the outlet of my domain to my inlet, so it has a offset and it is 90 degrees rotated. I tried to use "offsetMode normal" but there I only can give a distance and not a vector as offset. Someone know how to do this? K |
|
May 1, 2017, 04:40 |
|
#2 |
New Member
Jujjavarapu Vighnesh
Join Date: Apr 2017
Posts: 9
Rep Power: 8 |
I had to do a simple pipe with dimension that of micrometers.
I was always getting error. So I switched to salome for meshing.it is solved |
|
May 1, 2017, 05:59 |
|
#3 |
Member
Arnout
Join Date: Nov 2010
Posts: 46
Rep Power: 15 |
Thank for you're response. My problem is that I need to use a sampling plane which is not parallel to the inlet plane. Seems impossible without writing code myself.
Sent from my iPhone using CFD Online Forum mobile app |
|
May 1, 2017, 21:14 |
|
#4 |
New Member
Jujjavarapu Vighnesh
Join Date: Apr 2017
Posts: 9
Rep Power: 8 |
Are you trying to do a 90degree bend pipe
|
|
May 4, 2017, 00:57 |
|
#5 |
Member
Arnout
Join Date: Nov 2010
Posts: 46
Rep Power: 15 |
||
July 22, 2017, 11:29 |
|
#6 |
New Member
Jujjavarapu Vighnesh
Join Date: Apr 2017
Posts: 9
Rep Power: 8 |
I guess it can be done in Salome
|
|
August 28, 2017, 10:03 |
|
#7 |
New Member
Jujjavarapu Vighnesh
Join Date: Apr 2017
Posts: 9
Rep Power: 8 |
Hello sir , i am doing a project in which the geometry of the pipe is 90 degree bent pipe.i used salome to create the geometry and mesh it but was unable ti set the number of meshes.i hope that you have done it in openfoam using blockmesh.Can you please help me on how you did it ?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem of mappedPatch type | ldxfx | OpenFOAM Pre-Processing | 2 | September 4, 2020 02:04 |
Cyclic (mappedPatch) with LTSInterFoam in a closed channel | Phil_ | OpenFOAM Running, Solving & CFD | 0 | April 13, 2015 09:19 |
mappedPatch for two fluid regions | Vesposo | OpenFOAM Running, Solving & CFD | 0 | July 22, 2014 09:18 |
mappedPatch with channel flow | ArathoN | OpenFOAM Running, Solving & CFD | 57 | June 16, 2014 04:23 |
mappedPatch and weird profiles | Danubi | OpenFOAM Running, Solving & CFD | 0 | April 27, 2014 07:46 |