|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
omar osama
Join Date: Feb 2017
Posts: 3
Rep Power: 10 ![]() |
Hello,
I have a question concerning the set up of sprayFoam. I want to inject single species (Air) inside continuum Fluid (Water). I want to turn off the chemical reaction, heat transfer,...etc. is there any tutorial or advice? Thanks. |
|
![]() |
![]() |
![]() |
Tags |
lagrangian openfoam, multiphase flows, multispecies, openfoam, sprayfoam |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Injection injection-0: LOST 2 out of 20 injection locations | attaullah | FLUENT | 17 | March 2, 2023 11:31 |
[Other] Injection molding solver for OpenFOAM | krikre | OpenFOAM Community Contributions | 11 | September 11, 2021 10:44 |
How to contribute to the community of OpenFOAM users and to the OpenFOAM technology | wyldckat | OpenFOAM | 17 | November 10, 2017 16:54 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 04:52 |
The OpenFOAM extensions project | mbeaudoin | OpenFOAM | 16 | October 9, 2007 10:33 |