CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

3 D wing

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   November 6, 2018, 14:34
Default 3 D wing
  #1
New Member
 
Arslan
Join Date: Feb 2018
Location: Germany
Posts: 5
Rep Power: 4
ArslanAlvi is on a distinguished road
Hello all, i am working on 3D wing at 5 degree in square computational domain. I have small doubt regarding velocity vectors and lift and drag directions. As i have given 5 degrees to my wing in CAD. My inlet velocity is 1 m/s. Now do i need to give velocity also in x and y or (1 0 0) will work. Same question for lift and drag direction in force coefficients. Earlier in 2D case i have give lift and drag directions at every angle of attack.
ArslanAlvi is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Ffd_control_point_2d feiyi SU2 4 September 30, 2019 13:42
[ANSYS Meshing] Meshing fluid around sharp edges of a 3D insect wing. minglis ANSYS Meshing & Geometry 1 February 2, 2017 10:14
Using the wing mesher GavinB STAR-CCM+ 1 November 20, 2015 02:14
[ICEM] Blocking For Swept Wing air_engineer_arsenal ANSYS Meshing & Geometry 13 July 24, 2012 12:52
[snappyHexMesh] Meshing 3D wing (hydrofoil) fails klausb OpenFOAM Meshing & Mesh Conversion 0 December 28, 2011 15:26


All times are GMT -4. The time now is 15:32.