 |
 |
 |
|
|
|
[Sponsors] | ||||
Solid Walls in fluent.msh file was not recogonized by OpenFoam |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 17, 2019, 06:09
|
Solid Walls in fluent.msh file was not recogonized by OpenFoam
|
#1 |
|
New Member
Dinesh
Join Date: Jun 2018
Posts: 15
Rep Power: 7  |
Hi everyone,
I am facing a trouble when I tried to import fluent.msh file to OpenFoam. I am trying to simulate compartment fire for that I created my geometry and mesh using ICEM CFD. My geometry consist of solid compartment walls inside the fluid domain and a solid burner inside the compartment. When I tried to import my mesh to OpenFoam my solid walls were not recognized by openfoam, only I could see the fluid domain. I request you all to provide your valuable help and support for my issue. Thank you |
|
|
|
|
|
| Tags |
| openfoam v812 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] swak4foam for OpenFOAM 4.0 | mnikku | OpenFOAM Community Contributions | 80 | May 17, 2022 08:06 |
| [foam-extend.org] Problems installing foam-extend-4.0 on openSUSE 42.2 and Ubuntu 16.04 | ordinary | OpenFOAM Installation | 19 | September 3, 2019 18:13 |
| [swak4Foam] funkySetFields compilation error | tayo | OpenFOAM Community Contributions | 39 | December 3, 2012 05:18 |
| 2.0.x on Mac OSX | niklas | OpenFOAM Installation | 74 | March 28, 2012 16:46 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
