 |
 |
 |
|
|
|
[Sponsors] | ||||
April 17, 2019, 06:19
|
mapFields surface
|
#1 |
|
New Member
Join Date: Oct 2010
Posts: 23
Rep Power: 16  |
Hi,
I'm trying to take the surface mesh and scalar field S shown in the 3D image at the "top" patch and copy it to a new patch/mesh. Then I wish to extrude this 2D mesh and scalar field into a new 2D study with the values of the field S at cell centres. I've tried various connotations of mapFields and extrudeMesh without success  and would greatly appreciate any suggestions.I'm using OF v5.0. Thanks! Tom |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |
Linear Mode
