chtMultiRegionSimpleFoam: colling a thin film
1 Attachment(s)
Hi,
i attached a picture of a simplified heat exchanger. There is a thin (40µm = 0,04mm) film made from polyamide to be cooled with air. The thin film runs with speed in z direction (notice the coordinate system) through the heat exchanger. The film should be cooled with air. Can i have a solid body (the polyamide film) moving with velocity throught the heat exchanger? I think that will only work with fluids. Next, How do i mesh the thin film? Regards, fanta |
All times are GMT -4. The time now is 17:19. |