 |
 |
 |
|
|
|
[Sponsors] | ||||
July 11, 2020, 07:49
|
Problem with boundary/interface
|
#1 |
|
New Member
andrea chianese
Join Date: May 2020
Posts: 3
Rep Power: 5  |
hi guys
I'm new in OF and i have a problem so I'll try to explain it and get back a solution. I have 3 different closed geometry (Duct-Filter-Airbox). I tried to mesh them with snappyHexMesh and, for the first time, the mesher didn't create the boundary for the interface but only 2 faceZone (duct_to_filter , filter_to_airbox). I hoped that, as inolther cases, it would have created the boundaries. After that I would know why it didn't create the interface and if I want to create them manually, how should i do them? Because I saw the createBafflesDict but i don't know how it works. thanks for helping me |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SU2-7.0.1 on ubuntu 18.04 | hyunko | SU2 Installation | 7 | March 16, 2020 04:37 |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Linear Mode
