Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

How to create the free surface interface in OpenFOAM for two phase flow.

Mark Forums Read

Reply

Search this Thread

October 1, 2020, 03:50	How to create the free surface interface in OpenFOAM for two phase flow.	#1
ht2017 Member ESI Join Date: Sep 2017 Posts: 49 Rep Power: 9	Now I am simulating CFD for my project but I don't know how to create the free surface interface in OpenFoam. My simulation has shown below the picture it is a two-phase flow simulation. My project requested have to use the DNS turbulence model to resolve. [IMG]https://ibb.co/5sfFJW7] please give me any advice! thank you so much

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 05:45
Radiation in semi-transparent media with surface-to-surface model?	mpeppels	CFX	11	August 22, 2019 07:30
homogeneous free surface flow with phase change.	Niru	CFX	13	December 26, 2013 10:27
How to create a free surface application in Openfoam ?	phuchuynh	OpenFOAM	28	September 21, 2011 03:35
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07

All times are GMT -4. The time now is 17:34.