help!!problem in openfoam when i use icem mesh file with cyclic boundary condition
my openfoam version is 2.0
when i use ansys icem make a mesh file and fluent3DMeshToFoam,is ok. but the solver cannot keep going,it print this: FAOM FATAL ERROR: face 9912 area does not matchneighbor by 9.142%--possible face ordering problem . this face area is the boundary which i set cyclic condition . though i used createPatch code,it does not work,the same problem it print out. please help me |
All times are GMT -4. The time now is 09:55. |