 |
 |
 |
|
|
|
[Sponsors] | ||||
Appropriate boundary type for reactor fuel simulation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 2, 2022, 12:17
|
Appropriate boundary type for reactor fuel simulation
|
#1 |
|
New Member
Fuad Hasibul Hasan
Join Date: Feb 2022
Location: Dhaka, Bangladesh
Posts: 7
Rep Power: 4  |
I have created a model of a fuel pin in chtMultiRegionFoam which is consisted of three concentric cylinders: the innermost and the middle one contains two different solids and the outermost one contains fluid that receives heat from the inner cylinders. But in the actual situation, this thing is repeating. So I need an appropriate boundary condition for the outermost surface. I think it should be cyclic. Is it right? If it is, how should I implement it?
The complete reactor and what I am modeling are attached here. Here I am modeling the central red rod as the my_domain.png file looks like. |
|
|
|
|
|
| Tags |
| boundaries, boundary condition, cyclic boundaries |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
| time step continuity problem in VAWT simulation | lpz_michele | OpenFOAM Running, Solving & CFD | 5 | February 22, 2018 19:50 |
| Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
| Divergent temperature in chtMultiRegion(Simple)Foam | akrasemann | OpenFOAM Running, Solving & CFD | 13 | March 24, 2014 02:54 |
| Error during initialization of "rhoSimpleFoam" | kornickel | OpenFOAM Running, Solving & CFD | 8 | September 17, 2013 05:37 |
Linear Mode
