CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Pre-Processing (
-   -   Initializing a case with Fluent data in OF15 (

johanna February 12, 2009 04:17

I have been learning OpenFoam
I have been learning OpenFoam for only few months and I don't know very much and one problem I'm facing right now is that I'd like to initialize a case with Fluent data. There were some messages I found about this subject, but it still left me a little confused about how difficult it would be.
I'm using the 1.5 version of OpenFoam.

venkateshtl February 12, 2009 04:36

what type of messege u found?
what type of messege u found?

johanna February 12, 2009 05:08

There was this message "Fluent
There was this message "Fluent to Foam" in May 2008. Where someone asked about this...

And then in very old discussion from 2006
"Convert exisiting data to openfoam", there is a mention about possible "fluentDataToFoam" utility.

All times are GMT -4. The time now is 20:38.