 |
 |
 |
|
|
|
[Sponsors] | ||||
August 4, 2008, 11:42
|
How can I set up internal face
|
#1 |
|
New Member
Axel Hackbarth
Join Date: Mar 2009
Posts: 6
Rep Power: 17  |
How can I set up internal faces which are not considered in calculations.
I have some annoying 'Default Faces' on the outer hull of my boundary layer (created with GMSH), where no faces are supposed to be (in between boundary layer volume and outer polyhedral volume). No clue how I can get rid of them, but defining them as 'invisible' would be a good workaround. Regards, Axel |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Internal faces conditions | caio_cfd | OpenFOAM Pre-Processing | 0 | September 17, 2008 09:35 |
| boundary conditions for internal faces | Tom Pendrey | FLUENT | 1 | March 5, 2007 18:25 |
| Undefined internal faces becoming default patches | hjasak | OpenFOAM Pre-Processing | 1 | June 16, 2006 10:25 |
| Boundary Condition of internal Faces | Gernot | FLUENT | 5 | August 26, 2005 13:02 |
| interior and internal faces | jx | FLUENT | 0 | January 8, 2004 08:29 |
Linear Mode
