I am running a case by FoamX.
 

I am running a case by FoamX. It is running but it cannot be seen in the Process Editor Window (RMB_on_Case_In_The_CaseBrowser/StartProcessEditor). I have created:
OpenFOAM/jobControl/finishedJobs
OpenFOAM/jobControl/runningdJobs
but they are empty, too.
Thanks!

Hi Boyko, by default writin
 

Hi Boyko,

by default writing the job information is switched off. You can enable it by putting in your ~/.OpenFOAM-1.0.2/controlDict an entry of the form

InfoSwitches
{
writeJobInfo 1;
}

(or if the entry already exists change the value from 0 to 1)

Make sure the InfoSwitches and/or writeJobInfo occurs only once - OpenFOAM will not start up otherwise.

Mattijs