Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

BC for the side wall of a cylinder

Mark Forums Read

Reply

Search this Thread

June 5, 2009, 08:42	BC for the side wall of a cylinder	#1
grig Guest Posts: n/a	Hi, I am looking for a solution to implement a boundary condition that allows to have a gas injection in the side wall of a cylinder. It can be either a point injection or a "hole" with a small diameter. I plan to use coodles to solve the case. If anyone has some experience with similar problems and is willing to share, I would appreciate the help. I am quite new to OpenFOAM, so please pardon any of my possible 'lame' comment . Regards!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36
CFX Solver Memory Error	mike	CFX	1	March 19, 2008 07:22
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
[Commercial meshers] Converting meshes that includes interfaces	ham	OpenFOAM Meshing & Mesh Conversion	29	January 8, 2007 08:58
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12

All times are GMT -4. The time now is 17:13.