Solver buoyantBoussinesqPimpleFoam without turbulence
 

Dear, good night.
I'm working with the dreaded buoyantBoussinesqPimpleFoam and am facing difficulties in removing the turbulence model. I tried changing the RASProperties so:

__________________________________________________ ___________________________
RASModel laminar;

turbulence off;

printCoeffs off;
__________________________________________________ ___________________________

However, it did not work. How to change the code buoyantBoussinesqPimpleFoam to fully remove the turbulence model?

Another question. The buoyantBoussinesqPimpleFoam has already incorporated the heat exchanges by radiation, including the calculation of form factors between surface? If not, how can I include this heat balance?

Nobody has an interest in the subject in question?