Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Programming & Development

Implementing a stress on a portion of interface when using interFoam

Updated Threads

Reply

Search this Thread

May 18, 2014, 00:55	Implementing a stress on a portion of interface when using interFoam	#1
Kleiber New Member Yang Liu Join Date: May 2013 Posts: 3 Rep Power: 12	Dear all, I'm new to OpenFOAM, especially the VOF. I'm now trying to run a case using interFoam. It's about modeling the flow of a liquid film. I want to implement a force on a certain part of the interface to make the film flow, but I'm not sure how to achieve that since the interface is constantly moving. Can you guys give me some help on that? I really appreciate that. Best regards

Reply

Tags

interface, interfoam, stress

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Compute shear stress interFoam	hsieh	OpenFOAM Post-Processing	58	June 20, 2022 04:15
Implementing a dynamic retention force in interFoam	u2947	OpenFOAM Programming & Development	2	June 17, 2013 09:14
interFoam with dynamic contact angle: distorted interface	michielm	OpenFOAM Running, Solving & CFD	4	December 20, 2012 07:54
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 20:09

All times are GMT -4. The time now is 18:45.