 |
 |
 |
|
|
|
[Sponsors] | ||||
How to read boudary conditon setting in functionObject? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 7, 2018, 12:56
|
How to read boudary conditon setting in functionObject?
|
#1 |
|
Member
ff
Join Date: Feb 2010
Posts: 81
Rep Power: 16  |
Hi,
I am developing a functionObject, in which some part of function is dependent on boundary conditions' setting. For example, when It work on externalWallHeatFluxTemperature patch, I need to know this patch is setting as which mode (power, flux, or heatTransferCoeff). So I will need some like the following ...... Temperature.boundary()[patchi].lookup......('mode') However, it looks like these settings on boundary is not registried, so I don't know if there is a way to read it out in functionObject during simulation. Can anyone help me on this? Thanks very much. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| [Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
| 999999 (../../src/mpsystem.c@1123):mpt_read: failed:errno = 11 | UDS_rambler | FLUENT | 2 | November 22, 2011 09:46 |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
| Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 14:37 |
Linear Mode
