|
[Sponsors] |
June 24, 2015, 01:04 |
my boundary condition is not recognized
|
#1 |
Member
Neilson Whit
Join Date: Aug 2011
Posts: 74
Rep Power: 14 |
Dear All
I implemented a new temperature boundary condition based on the fixedValue boundary, I can compile it without any problem. However, when I run the case it gives following error : Code:
--> FOAM FATAL IO ERROR: Unknown patchField type compressible::MYfixedValue for patch type wall Note: --> I added new library into controlDict |
|
May 29, 2016, 12:27 |
|
#2 |
New Member
shrawasti
Join Date: Jul 2015
Posts: 5
Rep Power: 10 |
hi neilson,
did you find solution to your problem. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Outflow boundary condition in cartesian grid SIMPLE velocity-pressure coupling | ghobold | Main CFD Forum | 9 | September 19, 2015 02:50 |
Accessing multiple boundary patches from a custom boundary condition file | ripudaman | OpenFOAM Programming & Development | 0 | October 22, 2014 18:34 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |