 |
 |
 |
|
|
|
[Sponsors] | ||||
April 20, 2018, 09:58
|
reconstructPar keep getting error
|
#1 |
|
New Member
Fantastic Boy
Join Date: Oct 2017
Posts: 11
Rep Power: 8  |
Hi all,
My simulation is completed and it when start reconstructPar, I keep getting error which some of the data file such as U/ alpha/ U_0/ alpha_0/ etc contained symbols (1.234&9e-11) or the spcacing is replaced by 0 (1.234e-9 1.234e-900) or the e is replaced by u (1.234u-9) and others at different time step. I tried to rerun the simulation using by reducing no of processors but also no use. I will try to reinstall openfoam 5 later. Is there anyone face this kind of issue before and anyone know what's happen with that, is that a bug? Thank You |
|
|
|
|
 |
| Tags |
| openfoam 5.0, reconstructpar |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
| OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
| Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
| Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit) | Yogini | Fluent UDF and Scheme Programming | 7 | October 3, 2012 07:24 |
Linear Mode
