CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Programming & Development (https://www.cfd-online.com/Forums/openfoam-programming-development/)
-   -   How to applied cyclic boundary condition in zigzag channel? (https://www.cfd-online.com/Forums/openfoam-programming-development/225248-how-applied-cyclic-boundary-condition-zigzag-channel.html)

anhkenyt March 20, 2020 03:07
How to applied cyclic boundary condition in zigzag channel?
 
https://drive.google.com/open?id=1NG...-JYAByua1C5z3Hhttps://drive.google.com/open?id=1NG...-JYAByua1C5z3Hhi, foamer
I have a zigzag channel in the figure below. Instead of applying cyclic boundary with 2 faces are beginning and ending of every cycle, I want to use just 2 faces are beginning and half-cycle (red line in the figure).
Do you have any suggestions and OpenFoam can do that?
Thank you so much!

anhkenyt March 20, 2020 03:13
How to applied cyclic boundary condition in zigzag channel
 
1 Attachment(s)
hi, foamer
I have a zigzag channel in the figure below. Instead of applying cyclic boundary with 2 faces are beginning and ending of every cycle, I want to use just 2 faces are beginning and half-cycle (red line in the figure).
Do you have any suggestions and OpenFoam can do that?
Thank you so much!
https://drive.google.com/open?id=1NG...-JYAByua1C5z3H


All times are GMT -4. The time now is 16:00.