|
[Sponsors] |
August 31, 2021, 01:59 |
Access to cells density value
|
#1 |
Senior Member
mohammad
Join Date: Sep 2015
Posts: 274
Rep Power: 11 |
Hi All,
I am wondering if there any possibility to have access to the cells density value and making change in them? I wanna change the density value in some specific cells that I know their IDs. How is this possible? Cheers, Mohammad |
|
September 7, 2021, 16:24 |
|
#2 |
Senior Member
Lasse Brams Vinther
Join Date: Oct 2015
Posts: 112
Rep Power: 10 |
Hello Mohammad,
Can you please elaborate upon the meaning of cell density? Do you wish to refine the mesh in certain areas or near a certain edge? Regards, Lasse |
|
September 7, 2021, 19:43 |
|
#3 |
Senior Member
mohammad
Join Date: Sep 2015
Posts: 274
Rep Power: 11 |
||
September 8, 2021, 13:33 |
|
#4 |
Senior Member
Lasse Brams Vinther
Join Date: Oct 2015
Posts: 112
Rep Power: 10 |
Hello Mohammed,
I would look into fvOptions and fixedValueConstrain. This can be applied to a cellZone or just cells with certain id's by specifying all cells and then get the cell id which is needed. Let me know if you need further assistance. Regards Lasse |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why is there an under-relaxation factor for density and body forces? | bikooo3878 | FLUENT | 7 | October 30, 2018 12:42 |
[ICEM] Geometric density sources in ICEM | rana41671 | ANSYS Meshing & Geometry | 2 | June 14, 2018 05:44 |
How to model Salinity, density, fresh water & sea water | grayback87 | FLUENT | 3 | December 30, 2014 02:00 |
small density change for isothermal flows | hz283 | OpenFOAM | 1 | April 6, 2013 10:05 |
density update by UDF in non-premixed combustion | IKSOO | FLUENT | 2 | December 8, 2002 20:37 |