|
[Sponsors] |
![]() |
![]() |
#1 |
Senior Member
BastiL
Join Date: Mar 2009
Posts: 520
Rep Power: 18 ![]() |
Hi,
I want to write my own turbulence model. I looked into existing models in 1.5-dev and found some similar models. However, in my model I want to apply different formulations for epsilon and nut depending on the wall distance. I guess therefore I have to look over all cells to check wall distance for each cell? How is this loop done? I only found loops over faces in the wall-functions. The default behaviour seems to be to solve the equations globally not individually for echa cell, right? Thanks Bastian |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
SimpleFoam case with SpalartAllmaras turbulence model implemented | nedved | OpenFOAM Running, Solving & CFD | 2 | November 30, 2014 22:43 |
KOmega Turbulence model from wwwopenFOAMWikinet | philippose | OpenFOAM Running, Solving & CFD | 30 | August 4, 2010 10:26 |
SSG Reynolds Turbulence Model | Georges | CFX | 1 | February 28, 2007 16:15 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |