|
[Sponsors] |
May 13, 2010, 14:06 |
How to change boundary type?
|
#1 |
Senior Member
|
Hi Foamers,
in a code I need to set the boundary type to wall excepting for empty patches, in order to compute the distance of each cell from each boundary, and then set it back to their original type. How can I do that? I saw that exist a method called changePatchType, but I didn't success to call it from mesh.boundaryMesh().changePatchType(... ...) . Any suggestions? Thanks, Ivan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
[CGNS] CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 137 | December 14, 2018 05:20 |
Pressure instability with rhoSimpleFoam | daniel_mills | OpenFOAM Running, Solving & CFD | 44 | February 17, 2011 18:08 |
RasInterFoam STRANGE RESULTS AT BOUNDARY | kumar2 | OpenFOAM Running, Solving & CFD | 8 | March 24, 2008 19:38 |
How to change the boundary type during computation | Lee | Siemens | 2 | November 28, 2003 22:01 |