|
[Sponsors] |
May 13, 2010, 13:06 |
How to change boundary type?
|
#1 |
Senior Member
|
Hi Foamers,
in a code I need to set the boundary type to wall excepting for empty patches, in order to compute the distance of each cell from each boundary, and then set it back to their original type. How can I do that? I saw that exist a method called changePatchType, but I didn't success to call it from mesh.boundaryMesh().changePatchType(... ...) . Any suggestions? Thanks, Ivan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
[CGNS] CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 137 | December 14, 2018 04:20 |
Pressure instability with rhoSimpleFoam | daniel_mills | OpenFOAM Running, Solving & CFD | 44 | February 17, 2011 17:08 |
RasInterFoam STRANGE RESULTS AT BOUNDARY | kumar2 | OpenFOAM Running, Solving & CFD | 8 | March 24, 2008 18:38 |
How to change the boundary type during computation | Lee | Siemens | 2 | November 28, 2003 21:01 |