|
[Sponsors] |
heat Transfer between simpleFoam and laplacianFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 31, 2022, 10:32 |
heat Transfer between simpleFoam and laplacianFoam
|
#1 |
Member
Join Date: Oct 2011
Posts: 49
Rep Power: 14 |
Hi,
i need some hints before i get startet. I have an own solver for laminar flow of a fluid without phase change. The temperature of the fluid is calculated and all i want is to pass the temperature to the wall-interface of the solid surrounding the fluid, the fluid heats the solid then with laplacianfoam. Geometrically it is basically a pipe through a solid. I found precice, a coupling library which could be able to do this. But do i need this? At the end i want to add some fvOptions to place heating elements to heaten the fluid through the solid, partially. Who has some hints? Can it be done with chtMultiRegionSimpleFoam? Should i take precice? |
|
July 31, 2022, 20:50 |
|
#2 |
Senior Member
|
MultiregionFoam should be sufficient to solve your case
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat transfer in an engine block | lucchini | OpenFOAM Running, Solving & CFD | 3 | August 23, 2008 06:01 |