|
[Sponsors] |
May 2, 2012, 05:17 |
MRFSimpleFoam setup
|
#1 |
Senior Member
|
Hello Guys,
I have a simple question, I have tried the case in simpleFoam, it is working fine Now I am trying to run the same case in MRFSimpleFoam, for this, 1) What are the corrections I need to do, in my files. 2) I have copied my simpleFoam polyMesh folder in to MRFSimpleFoam/ fanTest folder 3) the I have executed blockMesh, while comparing the polyMesh folder with mixerVessle2D, cellZone file is missing. what should I do? give me your suggestions please with regards, Sivakumar |
|
May 2, 2012, 14:35 |
|
#2 |
Senior Member
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
MRFSimpleFoam Tutorial | bastil | OpenFOAM Running, Solving & CFD | 48 | August 1, 2012 10:00 |
about MRFSimpleFoam and ggi | wllmk1 | OpenFOAM Running, Solving & CFD | 0 | February 5, 2011 04:52 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2009 21:58 |
setup vof test problem | Fang Jin | FLUENT | 1 | June 14, 2005 08:27 |