Patch order in 'boundary'

Attesz · May 9, 2012, 06:03

Hi all,

is it a problem if I modify the order of patches in the constant/polyMesh/boundary file? If I run checkMesh or renumberMesh afterwards, I'm getting errors...

Thank you

olesen · May 10, 2012, 05:47

Quote:

Originally Posted by Attesz

Hi all,

is it a problem if I modify the order of patches in the constant/polyMesh/boundary file? If I run checkMesh or renumberMesh afterwards, I'm getting errors...

Thank you

I would NOT do this.
Although each patch has both startFace and nFaces, there are undoubtedly many sections of code that only use the startFace from the first patch and index through by using the nFaces from each patch.

May 9, 2012, 06:03	Patch order in 'boundary'	#1
Attesz Senior Member Attesz Join Date: Mar 2009 Location: Munich Posts: 368 Rep Power: 18	Hi all, is it a problem if I modify the order of patches in the constant/polyMesh/boundary file? If I run checkMesh or renumberMesh afterwards, I'm getting errors... Thank you __________________ I am doing CFD Consulting Services. Ich biete CFD Strömungssimulationen an.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Domain Imbalance	HMR	CFX	5	October 10, 2016 05:57
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
2nd order boundary conditions for 2nd order discretization?	quarkz	Main CFD Forum	30	December 26, 2011 07:12
Please help with flow around car modelling!	Tudor Miron	CFX	17	March 19, 2004 19:23