Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Running, Solving & CFD

Master and Slave patches from a splitMesh

Updated Threads

Reply

Search this Thread

August 28, 2012, 13:54	Master and Slave patches from a splitMesh	#1
Hisham Senior Member Hisham Elsafti Join Date: Apr 2011 Location: Braunschweig, Germany Posts: 257 Blog Entries: 10 Rep Power: 17	Dear Foamers, I am using the splitMesh utility to make two patches from one internal faceSet. The process yields two identical patches (master and slave). Is there a way to figure out which patch is facing which direction??? Using a rule of thumb or paraFoam maybe!! Regards Hisham

August 28, 2012, 13:59		#2
Hisham Senior Member Hisham Elsafti Join Date: Apr 2011 Location: Braunschweig, Germany Posts: 257 Blog Entries: 10 Rep Power: 17	patchNames from paraFoam .... The name rotates with the view! Last edited by Hisham; August 28, 2012 at 15:03.

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Floating point exception error	Alan	OpenFOAM Running, Solving & CFD	11	July 1, 2021 21:51
stop when I run in parallel	Nolwenn	OpenFOAM	36	March 21, 2021 04:56
openfoam 1.6 on debian etch	romant	OpenFOAM Installation	9	May 6, 2010 02:26
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 17:04.