|
[Sponsors] |
August 28, 2012, 13:54 |
Master and Slave patches from a splitMesh
|
#1 |
Senior Member
Hisham Elsafti
Join Date: Apr 2011
Location: Braunschweig, Germany
Posts: 257
Blog Entries: 10
Rep Power: 17 |
Dear Foamers,
I am using the splitMesh utility to make two patches from one internal faceSet. The process yields two identical patches (master and slave). Is there a way to figure out which patch is facing which direction??? Using a rule of thumb or paraFoam maybe!! Regards Hisham |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Floating point exception error | Alan | OpenFOAM Running, Solving & CFD | 11 | July 1, 2021 21:51 |
stop when I run in parallel | Nolwenn | OpenFOAM | 36 | March 21, 2021 04:56 |
openfoam 1.6 on debian etch | romant | OpenFOAM Installation | 9 | May 6, 2010 02:26 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |