cannot show rusult in paraview about chtMultiRegionHeater tutoriakls

mscheng · September 19, 2012, 22:07

Hello,
After run the chtMultiRegionHeater, I cannot correctly view the result using "paraFoam" command. It can show me "0" time result, but not show me other time.
anybody know, why?

Thanks

treima · September 21, 2012, 05:15

Hello,

did you have a look at the containing run folder, if other time-steps are saved? That means, if the solver created other folders for the next time-steps? You should have a "0" folder, a "constant" folder, a "system" folder and other folders "<time>", i.e. "1".

regards
treima

September 19, 2012, 22:07	cannot show rusult in paraview about chtMultiRegionHeater tutoriakls	#1
mscheng New Member Maosong Cheng Join Date: Aug 2012 Posts: 19 Rep Power: 13	Hello, After run the chtMultiRegionHeater, I cannot correctly view the result using "paraFoam" command. It can show me "0" time result, but not show me other time. anybody know, why? Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM] ParaView suddenly does not show 3D plots	vishalsacharya	ParaView	0	November 17, 2011 00:02
Paraview does not show any images	Thriceguy	OpenFOAM	3	April 17, 2011 20:20
paraview installation woes	vex	OpenFOAM Installation	15	January 30, 2011 07:11
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 21:41
[OpenFOAM] Paraview doesnbt show up	kim	ParaView	3	September 21, 2005 22:51

September 21, 2012, 05:15		#2
treima Member Join Date: Mar 2012 Location: Munich, Germany Posts: 67 Rep Power: 14	Hello, did you have a look at the containing run folder, if other time-steps are saved? That means, if the solver created other folders for the next time-steps? You should have a "0" folder, a "constant" folder, a "system" folder and other folders "<time>", i.e. "1". regards treima