|October 12, 2012, 23:22||
Parallel run Slows with Field average
I just discovered something strange. I am doing something wrong but I am not able to figure it out.
I will first define my problem. I have a mesh of 3M cells, which I am running on 216 processors in parallel. The decomposition is hierarchical (6 6 6).
I don't have any issues with the simulation until I start fieldAveraging over time, the simulation suddenly slows down a lot. To give you an idea if 4 corrector steps without averaging were taking 2.4 s approx, and with averaging the time goes to 33-37 s approx.
And this has been bugging me because if I kept going on this pace, I will finish the simulation in 6 months.
|Thread||Thread Starter||Forum||Replies||Last Post|
|problems after decomposing for running||alessio.nz||OpenFOAM||6||December 23, 2015 15:27|
|Superlinear speedup in OpenFOAM 13||msrinath80||OpenFOAM Running, Solving & CFD||18||March 3, 2015 06:36|
|Interfoam blows on parallel run||danvica||OpenFOAM Running, Solving & CFD||16||December 22, 2012 03:09|
|Can't run in parallel||JulytoNovember||OpenFOAM Running, Solving & CFD||2||March 31, 2012 09:28|
|Problem with rhoSimpleFoam||matteo_gautero||OpenFOAM Running, Solving & CFD||0||February 28, 2008 07:51|