which solver should be choose about a stirred tank?

sharonyue · October 23, 2012, 23:28

Hi Foamers

I want to simulate a gas- liquid stirred tank . when the agitator blade is running the gas is injected at the bottom.
I check out the solvers , bubbleFoam and twoPhaseeulerFoam maybe suitable for this. but twoPhaseeulerFoam has lots paremeters which bubbleFoam dont have.
so which solvers should I pick?
Thanks very much.

before I simulate the stirred tank, I try to simulate air being injected into water using twoPhaseEulerFoam.
seems like both air and water should be continuous phase， but in twoPhaseEulerFoam I have to set a dispersed phase. even if I set the air or the water is the dispersed phase, how can I know the da or db?

sharonyue · October 25, 2012, 07:14

can anybody help me about this? I have been obstructed by this for two days.

jiez · October 25, 2012, 09:00

Hi sharonyue,

I'm also working on this issue right now. I tried interFoam as well. I would suggest you to test these solvers first by comparing with experimental data.

There is another thread about this issue
http://www.cfd-online.com/Forums/ope...ated-tank.html

Jie

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DPM particle tracking in stirred tank	parisa-	FLUENT	1	August 7, 2012 12:03
Boundary conditions of stirred tank (urgent) please	shadyenany	ANSYS Meshing & Geometry	1	September 15, 2011 20:40
Working directory via command line	Luiz	CFX	4	March 6, 2011 20:02
sliding mesh for stirred tank modelling	Gopal Kasat	FLUENT	0	June 24, 2005 05:38

October 25, 2012, 07:14		#2
sharonyue Senior Member Dongyue Li Join Date: Jun 2012 Location: Beijing, China Posts: 838 Rep Power: 17	can anybody help me about this? I have been obstructed by this for two days.

October 25, 2012, 09:00		#3
jiez New Member Jie (Jay) Zhang Join Date: Sep 2010 Location: Phoenix, AZ, U.S. Posts: 28 Rep Power: 15	Hi sharonyue, I'm also working on this issue right now. I tried interFoam as well. I would suggest you to test these solvers first by comparing with experimental data. There is another thread about this issue http://www.cfd-online.com/Forums/ope...ated-tank.html Jie