Using simulation results as time-resolved boundary condition

vainilreb · November 15, 2012, 05:52

Hi,

I've had the idea of simulating a very small area with a really fine mesh and then take the results as input for a more coarse simulation in a larger area. But I don't simply want to define a start condition at the junction but to let them vary by time, just as calculated in the fine simulation before. I hope you get what I mean, I don't really know how to explain it in English. Is this possible and if so, how?

I really hope anyone can help me.

Robert

vainilreb · November 19, 2012, 01:55

Isn't there any possibility to do this?

In my case there is ammonia flowing into a room filled with air at high inlet velocities. Due to the high gradient in the gas concentrations at the inlet I have to keep the cell size extremely tiny. This makes the time step become extremely tiny. So I thought about calculating the process of gas inflow in a smaller control volume with very fine cells around the outlet and then use this control volume as inlet for a more coarse and faster calculation of the environmental setup.

Isn't this possible?

November 15, 2012, 05:52	Using simulation results as time-resolved boundary condition	#1
vainilreb Member Robert Join Date: Aug 2012 Location: Berlin Posts: 74 Rep Power: 13	Hi, I've had the idea of simulating a very small area with a really fine mesh and then take the results as input for a more coarse simulation in a larger area. But I don't simply want to define a start condition at the junction but to let them vary by time, just as calculated in the fine simulation before. I hope you get what I mean, I don't really know how to explain it in English. Is this possible and if so, how? I really hope anyone can help me. Robert

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Difficulty in calculating angular velocity of Savonius turbine simulation	alfaruk	CFX	14	March 17, 2017 06:08
Extrusion with OpenFoam problem No. Iterations 0	Lord Kelvin	OpenFOAM Running, Solving & CFD	8	March 28, 2016 11:08
the problem of my transient simulation "Floating point exception: Overflow "	alloveyou	CFX	15	November 22, 2012 11:14
External Radiation Boundary Condition (Two sided wall), Grid Interface	CFD XUE	FLUENT	0	July 8, 2010 06:49
New topic on same subject - Flow around race car	Tudor Miron	CFX	15	April 2, 2004 06:18

November 19, 2012, 01:55		#2
vainilreb Member Robert Join Date: Aug 2012 Location: Berlin Posts: 74 Rep Power: 13	Isn't there any possibility to do this? In my case there is ammonia flowing into a room filled with air at high inlet velocities. Due to the high gradient in the gas concentrations at the inlet I have to keep the cell size extremely tiny. This makes the time step become extremely tiny. So I thought about calculating the process of gas inflow in a smaller control volume with very fine cells around the outlet and then use this control volume as inlet for a more coarse and faster calculation of the environmental setup. Isn't this possible?