|
[Sponsors] |
June 27, 2013, 07:09 |
dam break having problem using setfields
|
#1 |
Member
subhendu
Join Date: Jun 2013
Location: kolkata,india
Posts: 39
Rep Power: 12 |
i am having problem when i give command setfields to the dambreak and run parafoam the result appears as it is fully occupied by water.whole control volume is shown in red
|
|
June 27, 2013, 08:31 |
|
#2 |
Member
subhendu
Join Date: Jun 2013
Location: kolkata,india
Posts: 39
Rep Power: 12 |
got the solution need to check the alpha1 not u in simulation
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem about setFields | williamscn | OpenFOAM Pre-Processing | 23 | December 9, 2018 00:15 |
Boundary Conditions in Gambit for a dam break model | Lindsey | FLUENT | 2 | October 5, 2009 02:53 |
dam break problem | sega | Main CFD Forum | 2 | April 23, 2008 11:39 |
Dam Break | Pratap | FLUENT | 0 | April 4, 2005 07:19 |
Initial conditions for dam break... | Gustaf Mårtensson | CFX | 1 | April 22, 2002 18:46 |