Rotating impeller with fluid inlet on it
Hello, guys
I would like to know if it is possible to simulate an impeller with a fluid inlet over it. Think about a garden sprinkler (but single phase). That would be a good image of it. Any ideas or examples? I am still not very experienced with OF, still too attached to CFX/Fluent way of thinking: - can you define some point fluid mass sources or you need to define proper inlets (BC's) for each inlet? As the mass flow is low and the inlet is small, I would go for point source, but don't know if it is possible. Many thanks Bayard |
All times are GMT -4. The time now is 21:25. |