Adaptive Refinement turbulence Model -- CFD Online Discussion Forums

September 13, 2013, 07:40	Adaptive Refinement turbulence Model	#1
Henning86 Member Join Date: Nov 2012 Posts: 83 Rep Power: 13	hi played a bit around with AMR. I found no hint that the turbulence model is updated after the refinement but it has stored the mesh distance as local variable. i only did refinement with the meshcutter but haven't found a hint on this in hexref8 as well. Best Regards Henning

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
An error has occurred in cfx5solve:	volo87	CFX	5	June 14, 2013 17:44
[snappyHexMesh] Adding layers goes wrong with SnappyHexMesh	Elise	OpenFOAM Meshing & Mesh Conversion	1	April 22, 2013 02:32
turbulence model for Refrigerator	cicatrix	Main CFD Forum	0	October 3, 2012 01:47
killed "snappyHexMesh"	parkh32	OpenFOAM Pre-Processing	2	April 8, 2012 17:12
Low Reynolds k-epsilon model	YJZ	ANSYS	1	August 20, 2010 13:57

All times are GMT -4. The time now is 16:39.