 |
 |
 |
|
|
|
[Sponsors] | ||||
October 4, 2013, 17:48
|
Automatic Mesh Refinement in OpnFOAM-1.6-ext
|
#1 |
|
Senior Member
Daniel
Join Date: Mar 2013
Location: Noshahr, Iran
Posts: 348
Rep Power: 21  |
Hello foamers
I am trying to run a FSI case with large deformation in which I need mesh refinement. I know there is class called dynamicRefineFvMesh but this class does not need a solver for mesh motion and that is a problem in my simulation. Is there any classes for automatic mesh refinement (based on skewness) which also incorporates a solver to move the mesh in OpenFOAM-1.6-ext (hex/prism)? Is it possible to refine two different region in OpenFOAM? regards |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh doesnt snap | staustrahltriebwerk | OpenFOAM Meshing & Mesh Conversion | 47 | March 18, 2018 14:19 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| [snappyHexMesh] Adding layers goes wrong with SnappyHexMesh | Elise | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 02:32 |
| [snappyHexMesh] snappyHexMesh refinement regions ignored | guitarbren | OpenFOAM Meshing & Mesh Conversion | 2 | April 9, 2013 03:59 |
| [snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
Linear Mode
