Unusual result on surface
1 Attachment(s)
Hi,
I'm working on a pipe like geometry (it's not cylinder). The pressure in outlet is 0.1 (m2/s2)and velocity in inlet is 0.05 (m/s), wall velocity is fixed value (uniform (0 0 0)) and its pressure is zero gradient. I run the case with icoFoam to see the results. It's showing that velocity is higher in the surface in compare to bulk! one picture of cross-section attached to show the higher velocity on surface and the geometry of case. Thanks for your comments and help Kind Regards |
another note!
again Hi!
I just want to add sth!! when I increase the kinematic viscosity from 1e-6 to 0.1, higher velocity is in the bulk instead of surface and makes more sense. I'm still waiting for any comments :) |
All times are GMT -4. The time now is 09:58. |