getting difficulties in developing fully developed flow through pipe.by openFoam
 

:confused:Can any one please tell me that how to get filly developed flow of air through rectangular pipe in Open Foam , i m using simple foam but not getting fully developed flow,only inlet showing the vectorial view of air not the full mesh including outlet too???M using pitzDaily for solving this problem.:confused: Attached Thumbnails http://www.cfd-online.com/Forums/blo...1&d=1391060496

Did you save a Iteration step ?

1. where is your inlet
2. are the vector orientations correct or do you want to have a flow from left to right?

3. with your smart description and Information ist not possible to give a hint.

Regards Tobi

Hello Tobi,

I would like to implement fully developed flow through a T-junction having one inlet with two outlets(also for two inlets with one outlet). It is having rectangular cross-section.

I am using Caelus 6.04 which is similar to OpenFoam.

Can you help me in implementing the fully developed velocity boundary condition at the inlet(s).

Thanks & Regards,
vidyadhar