|
[Sponsors] |
March 20, 2014, 07:39 |
How to treat the interface for MRFSimpleFoam
|
#1 |
Senior Member
|
Hi Foamers,
So far I am using conformal mesh for MRFSimpleFoam, now I want to use non-conformal mesh. I am using Gambit for meshing, and I defined the faces as interface. There are four interfaces, What kind of Bc I need to use like AMI, GGI? can I use AMI or GGI as follows, constant/polyMesh/boundary IF4 { type ggi; nFaces 13000; startFace 40391000; shadowPatch IF3; bridgeOverlap false; zone IF4_ZONE; } IF3 { type ggi; nFaces 26000; startFace 40404000; shadowPatch IF4; bridgeOverlap false; zone IF3_ZONE; } IF2 { type ggi; nFaces 23400; startFace 40430000; shadowPatch IF1; bridgeOverlap false; zone IF2_ZONE; } IF1 { type ggi; nFaces 13000; startFace 40453400; shadowPatch IF2; bridgeOverlap false; zone IF1_ZONE; } is it right way to define? Thanks, Sivakumar |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |